Re: 164 shift linkage

[Dan Scolaro <dan_scolaro@domain.elided>]

On Wednesday, February 27, 2002 6:29 PM, Obie Fayth <bibendum59@domain.elided>
wrote:
>Questions:
>1.) Yoke -- Does the yoke go on top of the rod or under it?
>2.) Rod -- Which side is up? The fitting on the end of the rod where it
>connects to the shifter lever is angled. The way I have it now, the fitting
>is parrallel to the l/r centerline of the car. If I flip it over the fitting
>will be angled to one side. Should it be parrallel or angled.
>3.) The hole in the firewall that the rod passes through seems to be too
>high. The rod rubs a little on the plastic seal. The motor mounts are all
>okay, do I just have the rod/yoke assembled wrong or is something else
>causing this?

Obie,

On the S shifter sitting in my basement, the yoke is under the shift linkage
rod and the shift lever fitting is angled toward the left (drivers) side of
the car.  Not sure about the rubbing.

HTH,

Dan Scolaro
Delaware Valley AROC   www.dvaroc.org
Phila, PA

65 2600 Spider
87 Milano Gold
91 164
88 Verde parts car (need anything?)

--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided